I have read and downloaded fromYouTube and other places lots of related material and I think I and understand clearly how to set parameters and what to expect at the screen. Both seem to have problems that sometimes the software freezes of does not seem repeatable with the same secondary ignition probe. I installed the software in a DELL Laptop Latitude D630 running windows 8.1 and also on HP pavilion with windows XP-Pro. Also have the DC Clamp CC650 with two ranges: 60 and 600 amps. ![]() I also purchased attenuator 1010 wich does a 10,000/1 and 20:1 attenuator for the Hantek. Also the content of some functions like Record/Play are 90% incomplete in detail. Both are difficult to say the least since it is probably written by a Chinese to English translator. ![]() I am working on a 1995 Toyota 4Runner of my neighbor and have installed the Hantek software version 10, the manual and installation guide. ![]() I also have an very Old analog Tektronix 465M purchased in eBay as a bargain years ago, that I thought would do the work, but apparently needs some repair or at least a major calibration and I do not have the equipment required as I have studied its manual. I an not an electronics Engineer but a retired Mechanical Engineer with enough interest in electricity and electronics to be able to understand how these function and limit of the instruments. Hi, just bought a Hantek 1008C for automobile diagnostics and I am having several problems that I would like to get some help with.įirst, I have read for about a month a lot about Oscilloscopes and their use.
0 Comments
Leave a Reply. |